- ページ 2

自動車アクセサリー Cipa 80100のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Cipa 80100 3 ページ。 Extendable replacement mirror

Note: Two people are required for proper installation of this product.

TEP

Removing Trim Piece and Stuffer Gasket

Open the door and roll the window completely

down.

Start at the top edge of the corner door trim piece

and gently pull away and down from the door to

disengage the spring steel clips. Once disengaged,

pull the trim piece upward to disengage it from the

door trim panel.

Gently pull the gasket from door pocket .

Set both pieces aside to be reinstalled later.

TEP

Disconnecting Electrical Connector –

Electric Mirrors Only

For manual mirror installation proceed to Step Three.

If you are installing an electric mirror, pull the wiring

harness out of the door to access the plug. Gently

pry the locking tab on the side of the plug and pull

the harness away. DO NOT allow the harness and

connector to fall into the door cavity.

TEP

HREE

Removing Factory Mirror

While a second individual holds the factory mirror,

use a 10mm deep well socket to remove the the

three 10mm nuts inside the door. Make sure not to

drop loose 10mm nuts into door cavity. Slowly

remove factory mirror from door.

If the vehicle is equipped with an electrical harness

feed it through as the mirror is removed.

Roll Window Down

Remove

Gasket

Wiring

Harness

Remove

10mm Nuts

Remove Trim Piece

Remove

Trim Piece

Area of Detail