- ページ 13

計測機器 Accurate Technology Digi Scale Model 10のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Accurate Technology Digi Scale Model 10 17 ページ。

Reverse Scaling

If you set a zero point on ProScale, moving the scale in one direction will produce

positive readings. Moving the scale past zero in the opposite direction will produce

negative readings. Reverse scaling means changing the orientation of the Encoder so

that positive readings become negative and negative readings become positive. There

are two methods to reverse readings:

1. Slide the Encoder off the scale and re-install the Encoder in the opposite

direction, being careful not to damage the ground fingers inside the Encoder.

2. Change the position of jumper JP1 on the Readout circuit board.

A "BAT" indicator will appear in the upper left corner of the LCD display when new

batteries are needed.

Remove the screws in the upper right and lower left corners.

Remove the old batteries.

orientation. Replace the cover and tighten the screws.

CAUTION:

THESE CLIPS ARE DESIGNED TO BE LOOSE WHEN THE CASE IS OPEN AND WILL COMPRESS

AND SECURE THE BATTERIES IN PLACE WHEN THE CASES ARE SCREWED TOGETHER.

Accurate Technology Digi Scale

Reinstall new AA Alkaline batteries, noting the proper

DO NOT BEND BATTERY CLIPS!

Pull the cover off.

Page 13 of 17