- ページ 7

計測機器 Accurate Technology Digi-StopのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Accurate Technology Digi-Stop 16 ページ。 Complete digital stop and fence system for chop saws, radial arm saws, and miter saws

ページを印刷する

Calibration

Once installed, Digi-Stop can be calibrated easily and quickly. The following is

an example of calibrating Digi-Stop on a cutoff saw application.

installations follow the same general procedure.

Cut a small part (approximately 8 inches) using the stop. DO NOT

MOVE THE STOP UNTIL THIS PROCEDURE IS COMPLETED.

Measure the length of the part with the most precise measuring tool

you have available (preferably digital calipers).

Press the

(PLUS) key to change the displayed reading until the length you just

measured is shown (The longer the

readout will scroll). This adjustment should be made in a decimal

(inches or mm) mode for the best accuracy.

When the correct reading is reached, lock the readout if desired. This

prevents accidentally re-zeroing during normal use.

See Section 3: Readout Lock Mode

Maintenance

The fence extrusion should be cleaned of debris periodically. Do not use any

liquid lubricants on the scale, as this may impede the encoder's ability to

operate properly and attract other contaminants to the scale.

If the stop becomes difficult to move, and the fence and scale have both been

cleaned, the plastic wing may need adjustment:

Position the wing to hold the locking mechanism of the stop in the

center of the extrusion slot.

The position of the wing can be adjusted after removing the plastic

guide clip and loosening the socket

screws (using a 3/16" hex wrench)

which sandwich the wing between

the stop and the aluminum block.

The wing is adjusted properly when the weight of the stop is supported

by the wing and the locking mechanism does not rub on the extrusion.

The readout should be cleaned periodically with compressed air to remove

any dust on the lens and keys. All fasteners should occasionally be checked

for tightness.

Accurate Technology DigiStop

key to 'zero' the readout, then press and hold the

DATUM

key is held down, the faster the

Other

Page 7 of 16