- ページ 6

アンプ AXTON A295のPDF インストレーション＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。AXTON A295 20 ページ。 Car audio system 1-/2-/4-channel power amplifiers

1. CONNECTIONS + CONTROLS A1300

1.1 CONTROLS

RCA INPUTS 1/2-CH

Low-level stereo RCA signal input 1/2-CH for connection to head-unit.

INPUT GAIN CONTROL 1/2-CH

Input gain potentiometer for channel L/R-CH, to match the output voltage of the head-

unit to the amplifier's input.

SUBSONIC HIGHPASS FREQUENCY CONTROL 1/2-CH

Control potentiometer to adjust the subsonic highpass filtering frequency point for

section L/R-CH of the amplifier.

Switch to select 6dB bass boost, or no boost with a 40 Hz center frequency of the

amplified output signal.

Control potentiometer to adjust the lowpass filtering frequency point for section L/R-CH

of the amplifier.

BASS LEVEL REMOTE CONTROL INPUT 1/2-CH

Input terminal to connect the external bass level remote to the amplifier.

HIGH INPUT 1/2-CH

Molex connector terminal to insert the High level adapter (4-pin) that picks up the

amplified speaker signals from the head unit's front or rear outputs (if head unit does not

feature dedicated RCA line outs).

1.2 INPUTS + OUTPUTS

POWER LED

LED to show "operating" status of the amplifier by green/red illumination. Green is

normal working state, red is protect state of amplifier.

"GND" POWER INPUT TERMINAL

Terminal to connect the amplifier to the chassis ground or negative pole of the car

battery.

10 "REM" INPUT TERMINAL

Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the

head unit.

11 "+12 V" POWER INPUT TERMINAL

Terminal to connect the amplifier to the positive +12V pole of the car battery.

12 ATC FUSE HOLDER

Fuse holder for 2 x 20 A ATC fuses. Never deploy fuses of higher amperage rating.

13 SPEAKER OUTPUT TERMINAL

Output terminal to connect the speakers to the amplifier in either stereo or bridged

mode.

– 10 –

1. CONNECTIONS + CONTROLS A1300

8 9

2 3 4 5

bl bm

– 11 –