- ページ 7

アンプ Arcam P49のPDF ハンドブックをオンラインで閲覧またはダウンロードできます。Arcam P49 13 ページ。 Integrated amplifier/pre-amplifier/power amplifier

ページを印刷する

P49/P349

operation

Switching on

The

POWER

button switches the unit on and off.

The power light (next to the 'POWER / STANDBY'

text) indicates the state of the amplifier: it changes from

red to orange then green if mains power is connected

and the unit is switched on.

POWER / STANDBY

SP1

SP2

SP1 and SP2

These buttons allow you to switch the speakers on and

off.

The LED above each button glows green to indicate

which speakers are currently selected. If you are using

the bi-wiring configuration described on page 15, both

SP1 and SP2 must be switched on.

Note that when both lights are out, the amplifier will

appear not to work, as all speakers are switched off.

E-12

CR902 remote

control

POWER

The CR902 is pre-programmed for use with the

A49.

Make sure the two AAA batteries supplied are

installed before attempting to use the remote

control.

A. With the CR902 remote face-down, press down

on the non-slip indentations of the battery

compartment cover and slide the cover off.

B. Insert the two 'AAA' batteries supplied. Take

care to insert the batteries in the right direction

by following the '+' and '–' marks in the battery

compartment.

C. Slide the battery compartment cover back and

lock it in place with a click.

The CR902 requires a clear line of sight to the front

panel display of A49 to ensure reliable operation.

Alternative code selection

In the rare sitatuation that the CR902 remote control

happens to operate another device in the room, the

IR code can be changed to an alternative RC5 system

number.

To change the remote control to the alternate code:

Press and hold the

key and press 1 and then 9 .

AMP

To restore to the original code:

Press and hold the

key and press 1 and then 6 .

AMP

Note: the selection of the alternate codes is reset when

the batteries are changed.

In addition to changing the remote handset, the A49/

C49 unit must also be reconfigured to respond to the

alternate codes. Either use the

button on the remote

to access the setup menu, or press the front panel

SAT

and

MUTE

buttons simultaneously and use the control

knob to change the setting. The front panel display shows

(e.g.) IR SYS 16.

E-13

INFO

AUDIO

RTN

FM MONO P/TUNE

STORE

SACD

CR902