- ページ 3

カーレシーバー AXTON AE402CのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。AXTON AE402C 17 ページ。 2-way component systems

CROSSOVER WIRING

The crossover can be mounted in almost any location inside the vehicle. Just make sure

not to install the crossover units, where they may be exposed to dirt or water.

Maintain polarities all the way – double check for correct connection. It is very important

to make sure that all the connections are electrically in phase, which means positive wire

(+ or red) is connected to positive terminal, and negative wire (- or black) is connected to

the negative terminal. The wires are equipped with the right fast-on connectors, to make

sure polarity is correct. Reverse polarity connections of the inline crossover to the ampli-

er, will cause a very low bass output and a messed up front staging.

MOUNTING THE MID/WOOFERS

Remove the factory grilles of the door – or if necessary – the complete door panels. The

EURO-DIN frame mid/woofer units provide bolt and screw holes to t a great variety of

OEM standard patterns, making them ideal for a direct replacement of factory installed

speakers in European or Asian cars.

Remove the factory installed mid/woofers or fullrange speakers. Before you attempt

to install the new AXTON mid/woofers, you must check the available installation depth

of the left and right front door. To do this, slide down both windows and hold the AXTON

mid/woofers in place to reassure the available installation depth does suf ce. This test is

important, failure to do this may let you end up with an impaired window function!

Connect the wire from the inline crossover to the main speaker wire in the door. For this

purpose, crimp connectors are suited best. Do this for both front doors.

Connect the crossover wires to the blade connector terminals of the mid/woofer units.

Pull the tweeter wire coming from the inline crossover into the loacation, where the

tweeter shall be mounted later on. If you fail to do so, you will have to remove the mid/

woofer in a later step.

Check that there are no gaps between the speakers and the mounting surface in the

doors. Note that some (newer) cars will require the use of car-speci c mounting adapters

made of pastic material. Without them, the Euro-DIN mid/woofers will not t to the OEM

cutout, or the available installation depth will not be suf cient. Such adapters are usually

available from your authorized AXTON dealer.

The cone and surround material of the mid/woofers is 100% water proof. However a

direct exposure of the mid/woofer to water inside the doors should be avoided. In most

cases, protection foils are pre-installed to protect the OEM full-range speaker. Do not rip

this foil out of the doors, it is there for a purpose!

Fix the mid/woofer to the speaker mounting hole using the provided screws. If the mid/

woofers are directly screwed onto the sheetmetal of the door, use the metal clips included

with the mounting hardware. You can now reinstall the factory plastic grilles, but make

sure the surrounds of the mid/woofers do not come in touch with plastic parts standing

off on the backside of the grilles.

In case you have chosen a new location for your mid/woofers (other than factory

cut-out), use the speaker protection grilles. Just mount them on top of the mid/woofers.

– 3 –