- ページ 4

自転車 Circe Cycles TripletのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。Circe Cycles Triplet 8 ページ。
Circe Cycles Triplet にも：オーナーズマニュアル (15 ページ)

• 15mm pedal spanner

• Di2 tool (STEPS Triplet) supplied

• Long nose pliers or chainlink pliers (Triplet)

INSTALLING STEERER EXTENDER

The steerer extender fits to the top of the fork and

locates on the 4-pointed star, the slot at the back

of the extender should align with the vertical slot on

the side of the top cap.

Ensure the steerer is fully pushed down before

tightening the Q/R.

Fit the handlebar to the stem using an Allen key

and tighten according to the torques settings in the

torque table Appendix A.

Extender

Top cap

CirceCycles.com

The front wheel is fitted using a thru axle, that is

pushed through from the left side of the bike (disc

brake side) and then tightened using a 6mm Allen

key. When installing the wheel make sure the disc

rotor is aligned between the pads, before pushing

the wheel into the fork ends.

NOTE – with hydraulic brakes, first remove the

orange pad spacer before installing the wheel.

The front mudguard attaches in three places; the

fork crown and hte bottom of each fork leg. You

will need a 6mm Allen key and 10mm spanner to

fasten the bolt at the fork crown and a pair of pliers

to help insert the stays into the plastic clips, though

this can be done by hand.

you have a front light or Hebie steering stabaliser

you will have to attach these at the fork crown with

the mudguard.