- ページ 4

アンプ Axxent AX1400TSのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axxent AX1400TS 4 ページ。 Professional power amplifier

user manual

models AX-1121TS / AX1240TS / AX 1400TS

Output connectors, low Impedance

Above the 3 pin xlr input connectors are the dual binding

posts that are used for the low impedance output of the am-

plifier. These binding posts are touch proofed according to

international safety regulations.

You may operate the amplifiers with four ohm load and full

power at all times. Please note however, that in this case you

may not use the constant voltage outputs. It is important to

know that combined power of simultaneous use of both con-

stant voltage and low impedance outputs may not be higher

than the r.m.s power of the amplifier. For example, if you use

an 8 ohm speaker at the low impedance output connector,

you will take approximately two thirds of the total available

power and the other third then may be used to drive 100 v

loudspeaker lines.

Input connectors

The amplifiers use fully balanced inputs for minimum interfer-

ence. The input is a three pin female xlr connector and the

"send" xlr connector is meant to route the input signal to

additional amplifiers. All standard microphone cables may

be used to connect the amplifier. Inputs are electronically

balanced and have a nominal impedance of 20 kohms.

Amplifier cooling

Amplifier models AX1121TS, AX1240TS and AX-1400TS use

convection cooling. Heat transfer is by the rear heat sink.

Because no fan is being used to transfer heat, there is no

operating noise at all.

CE Declaration of Conformity

We herewith declare in sole responsibility that the products AX1121T,

AX1240T and AX1400T are in conformity of EMC regulation 89-336-

EEC and fullfills the requirements of the uniform product standard

EN55013 (emission) and EN55020 (product immunity).

axxent e.K. • Technologiezentrum Herzbachtal • Zum Wartturm 15 • 63571 Gelnhausen

Fon: +49-6051-9165584 • Fax: +49-6051-9165585 • [email protected] • www.axxent.de