- ページ 3

インターホン・システム Axxent MS-200のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Axxent MS-200 4 ページ。 Intercom systems

CP-100 loudspeaker station

Due to its compact size this loudspeaker station is also favourably used as

a small main station. The model CP-100 may be looped in to the signal chain

like any of the other intercom components. It derives its supply voltage from a

main station via the microphone cable. LINE IN: This is the intercom connec-

tor for the microphone cable from the main station. LINE OUT: is for looping

through the system to other intercom stations. Right hand you will notice a

RJ-45 connector for supply voltage in case the loudspeaker station should not

get its voltage from another main station.

Controls on the front side

HEADSET connector (1); MIC connector (2). Instead of connecting a headset here

these inputs also can be used for connecting another external microphone such

as a gooseneck or handheld (dynamic). In this case the loudspeakers will be used

instead of the earphone. In case you use a headset you can disengage the built-

in loudspeaker with the SPKR switch (3). Right from this you will ﬁnd the CALL

button (4). Beneath is an ON/OFF switch for the buzzer alarm. The 3-position

talk switch (5) has the options: OFF, PTT (Push To Talk) and ON. The level of the

loudspeaker or the earphone of the headset is controlled by the potentiometer (6).

SIDE-TONE: To control the cue volume of your own microphone (7).

The model CP-100 features a very robust 1/2 19" steel case with rubber feet for

table use. In case you would like to mount the CP-100 in a 19" rack, we have avail-

able a rack mount kit RMK-100. It may also be mounted to the wall with a special

wall mount kit WMK-100.

ProAudio Technik Josef Becker · Zum Wartturm 15 · 63571 Gelnhausen (Germany)

Fon: +49-6051-9140-0 Fax: 9140-59

I N T E R C O M - S Y S T E M

Operation Manual

As indicated before the model CP-100 may be used as loudspeaker station

as well as a small main station. As a loudspeaker station the voltage is sup-

plied by a main station such as the models MS-200 or MS-100. In case you

prefer to operate the CP-100 as a small main station, an external power supply

RS-1 may be connected which in addition can provide operating voltage for up

to 4 beltpacks.

Controls on the rear side

LINE IN (8): This is the XLR intercom connector for the microphone connection

cable to the main station.

LINE OUT (9): Serves as loop through to other intercom stations. On the right

hand is the RJ-45 connector(10) which can be used for power supply of the unit

in case it is not powered by other main stations.

As mentioned before the CP-100 can be either used as a loudspeaker station or

as a small main station. As loudspeaker station the power supply is derived from

a main station such as the models MS-200 or MS-100. If your prefer the CP-100

as a small main station you may also connect the external power supply RS-1

which also can provide the operating voltage for up to 4 beltpacks.

[email protected] · www.proaudio-technik.de