- ページ 7

照明器具 Creche Innovations MicroCoolのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Creche Innovations MicroCool 12 ページ。 Led examination light
Creche Innovations MicroCool にも：取扱説明書 (12 ページ), ステーション・モードの説明 (8 ページ)

ページを印刷する

Maintenance

2.1 Fuse Replacement

If this product is operated according to procedures in this manual, the fuses that

are located internally at the base of the transformer housing may never need

replacing. But, if one or more system abnormalities do occur, the protective current

fuse (s) will fail and need to be replaced.

NOTE: Before replacing a blown fuse(s), a complete system check should be

Undertaken to reveal the underlying cause(s) for the failure. Appropriate corrective

action should be taken to prevent future occurrences.

2.1.1. Turn the power switch off (O) and disconnect the fixture from the mains supply

to avoid electrical shock.

2.1.2. Loosen the single screw on the transformer housing where the power cord enters.

Remove cover by lifting this end up and away, it will naturally pivot around the clip

at the opposite end.

2.1.3. Check and replace fuses located on the terminal block by pulling the black fuse holder,

tab up.

2.1.4. Reverse the above procedure to restore the fixture to proper operation.

2.2 LED Replacement

Note: The LED module will outlast the life expectancy of the device (10 years) under

normal conditions and it's therefore not needed to replace before this time period.

LED module replacement must be replaced by a Creche Innovations appointed

technician.

2.2.1. Turn the power switch off (O) and disconnect the fixture from the mains supply.

If the fixture was operating just prior to the LED failure, the heat sink is probably

to hot to handle. Allow at least 20 minutes for it to cool.

2.2.2. Remove the arm from the mount and lay it down on a flat surface, remove the four

screws on the front face of the light head and carefully separate the two halves, do

not over stress the wires from the switch to the LED module.

2.2.3. Remove the broken LED module with heat sink by first removing the four screws

around the heat sink, then disconnect the black and red wires from the LED board.

2.2.4. Insert the black and red wire into the new LED module and secure it to the housing

with the four screws from the previous step.

2.2.5. Secure the two halves of the light head. Ensure that wires are NOT being pinched.

2.2.6. Re-attach the light to the mount.

Maintenance