- ページ 3

キーパッド Digicode DGAのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Digicode DGA 20 ページ。 Surface-mount keypad - cast aluminium

ページを印刷する

INSTALLATION MANUAL

DGA

Cast aluminium Digicode

AUDIBLE SIGNAL

- 1 short beep

- 1 long beep

- 2 short beeps

- 4 short beeps

CODE LENGTH

- All the keypad keys can be used to program a code,

- The master code and the Pin code can be of 4, 5 or 6-digits,

- The master code CAN NOT be used as a PIN code (User Pin code),

- Codes 000000, 00000 and 0000 can only be used to delete a user code,

- To delete a specific User Code replace it by 0000 if code length is 4-digit format or replace it

by 00000 if the code is in 5-digit format.

REQUEST-TO-EXIT INPUT

P1 input activates relay 1. (The output can be programmed) :

- The timer input H1 if connected allows using the 0 key as a request-to-enter,

- If the timer contact is open then the 0 digit key is used for the Pin code,

- if the contact is closed then the 0 key is used for the request-to-enter.

CONSUMPTION

- 12V AC: in stand-by 20 mA, when 2 relay outputs activated 80 mA max,

- 24V AC: in stand-by 10 mA, when 2 relay outputs activated 40 mA max.

RESET MASTER CODE AND DELETE ALL USER CODES

1] Enter the master code twice (12345 default value master code):

- the red LED lights on to confirm entry in programming mode.

2] Press A6 to enter in the reset menu:

- the green LED lights on for 1 second,

- press simultaneously on A and B to start the reset,

- the green LED lights during all the reset process, wait until it lights off,

- the master code is reset to its factory value 12345 and all the user codes are deleted,

- the keypad is reset to the factory default values, the red LED lights on then lights off.

------------------------------------------------------ OR ---------------------------------------------------------

1] Turn off the power. Short the white and the yellow wires.

2] Power on the keypad:

- the green LED lights on,

- wait a few seconds, one beep is emitted. The green LED lights off. Unshort the wires.

3] The keypad is reset to the factory default values.

SETTING CODE LENGTH

1] Enter the master code twice (12345 default value master code) :

- the red LED lights on to confirm entry in programming mode

2] Press A4 to program the code length:

- the green LED lights on during 1 second,

- press 4, 5 or 6 to enter the code length,

Self Contained

Keypad powered,

data computing in programming or access granted,

Enter or Exit from programming,

Data computing error.

cdvi.se

cdvigroup.com