- ページ 28

プリンター Epson 2080 - LQ B/W Dot-matrix PrinterのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Epson 2080 - LQ B/W Dot-matrix Printer 29 ページ。 Impact printer
Epson 2080 - LQ B/W Dot-matrix Printer にも：仕様 (2 ページ)

ページを印刷する

Epson 2080 - LQ B/W Dot-matrix Printer マニュアル

EPSON LQ-2080

Cleaning the Printer

To keep your printer operating at its best, you should clean it

thoroughly several times a year. Follow these steps:

1. Make sure the printer is turned off. Then remove any paper

loaded in the printer.

2. Remove the paper guide. If a pull tractor or an optional cut-

sheet feeder is installed, remove it.

3. Use a soft brush to carefully brush away all dust and dirt

from the outer case and paper guide.

4. If the outer case or paper guide is still dirty, clean it with a

soft, clean cloth dampened with mild detergent dissolved in

water. Keep the printer cover in place and lower the paper

guide cover until it lies flat on the top of the printer to

prevent water from getting inside the printer.

Caution:

Never use alcohols or thinners to clean the printer; these

chemicals can damage the printer components as well

as the case.

Be careful not to get water on the printer mechanism or

electronic components.

Do not use a hard or abrasive brush.

Do not spray the inside of the printer with lubricants;

unsuitable lubricants can damage the printer

mechanism. Contact an EPSON dealer if you think

lubrication is needed.

28 - EPSON LQ-2080

Transporting the Printer

If you need to transport your printer some distance, carefully

repack it using the original box and packing materials, as

described below.

Warning:

You will need to move the print head by hand to

remove the ribbon cartridge. If you have just used the

printer, the print head may be hot; let it cool for a few

minutes before touching it.

1. Turn off the printer.

2. Unplug the power cord from the electrical outlet; then

disconnect the interface cable from the printer.

3. Remove any paper loaded in the printer, and remove the

paper guide. Pull out the paper separator from the paper

guide.

4. If a pull tractor is installed, remove it. If any options are

installed, remove them and pack them in their original

boxes.

5. Make sure that the print head is not hot. Then remove the

ribbon cartridge.

6. Remove the paper tension unit. Attach the protective

locking clips on both sides of the printer roller. Then install

the paper tension unit.

7. Make sure the tractor that came with your printer is

installed in the front push position.

8. Replace the transportation screw using the screwdriver that

came with the printer.

9. Repack the printer, ribbon cartridge, paper guide, and paper

separator in the original packing materials and place them

in the printer's original box.

- ページ 28

Cleaning the Printer

Transporting the Printer

Related Documentation