- ページ 26

プリンター Epson 220のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Epson 220 29 ページ。 Epson printer parts manual

ページを印刷する

EPSON LQ-2080

Changing Default Settings

Follow the steps below to enter the default-setting mode and

change the printer's default settings.

Note:

To print the language selection and default-setting mode instructions,

you need three sheets of letter- or A4-size single-sheet paper or three

pages of continuous paper that is at least 11 inches (279 mm) long

and 8.3 inches (210 mm) wide.

If you use single sheets, you need to load a new sheet of paper each

time the printer ejects a printed sheet.

You may exit the default-setting mode at any time by turning off the

printer when the printer is not printing.

1. Make sure paper is loaded and the printer is turned off.

Caution:

Whenever you turn off the printer, wait at least five

seconds before turning it back on; otherwise you may

damage the printer.

2. Hold down the

Condensed

button to turn on the printer. The printer enters

Operate

the default-setting mode and prints the language selection

instructions (one page).

3. Press the

button until the Font lights indicate the

Font

language you want, as described in the language selection

instructions.

4. Press the

button to print the default-setting

Condensed

mode instructions (two pages) in the language you selected.

The printed instructions list the default settings you can

change, describe how to change them, and show you how

the control panel lights help you make settings. Follow these

instructions to change the default settings using the buttons

on the printer's control panel.

Note:

The arrows on the instruction sheets indicate the printer's

current settings.

5. When you finish making your settings, press the

button to turn off the printer and exit the default-setting

mode. Any settings you make remain in effect until you

change them again.

26 - EPSON LQ-2080

button while you press the

Operate

Aligning Vertical Lines in Your

Printout

If you notice that the vertical lines in your printout are not

properly aligned, you can use the printer's bidirectional

adjustment mode to correct this problem.

Note:

To complete the steps below, you need four sheets of A3-size single-

sheet paper or four pages of continuous paper that are at least

11 inches (279 mm) long and 14.8 inches (376 mm) wide.

If you use single sheets, you need to load a new sheet of paper each

time the printer ejects a printed sheet onto the paper guide.

Follow these steps to perform the bidirectional adjustment:

1. Make sure paper is loaded and the printer is turned off.

Caution:

Whenever you turn off the printer, wait at least five

seconds before turning it back on; otherwise you may

damage the printer.

2. While holding down the

button to turn on the printer. The printer enters the

bidirectional adjustment mode and then prints instructions

and the first set of alignment patterns.

3. As described in the instructions, compare the alignment

patterns and select the pattern with the best alignment.

4. Follow the instructions to print the remaining sets of

alignment patterns and select the pattern with the best

alignment in each set.

5. After you select the best pattern in the final set of alignment

patterns, press the

and exit the bidirectional adjustment mode. Your selections

are saved automatically.

2/99

button, press the

Pause

button to turn off the printer

Operate