- ページ 4

プリンター Epson 24-PIN DOT MATRIX PRINTER LQ-680PROのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO 22 ページ。 24-pin dot matrix printer
Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO にも：クイック・リファレンス (12 ページ), ユーザーマニュアル (17 ページ), 仕様 (2 ページ), 仕様 (3 ページ), リファレンス・マニュアル (34 ページ), セットアップマニュアル (2 ページ)

Important Safety Instructions

Read all of these instructions and save them for later reference. Follow all warnings

and instructions marked on the printer.

Do not place the printer on an unstable surface or near a radiator or heat source.

Place the printer on a flat surface. The printer will not operate properly if it is tilted

or at an angle.

Do not block or cover the openings in the printer's cabinet. Do not insert objects

through the slots.

Use only the type of power source indicated on the printer's label.

Connect all equipment to properly grounded power outlets. Avoid using outlets on

the same circuit as photocopiers or air control systems that regularly switch on and

off.

Do not use a damaged or frayed power cord.

If you use an extension cord with the printer, make sure the total ampere rating of

all devices plugged into the extension cord does not exceed the cord's ampere rating.

Also, make sure the total of all devices plugged into the wall outlet does not exceed

the wall outlet's ampere rating.

Unplug the printer before cleaning, and clean it with a damp cloth only.

Do not spill liquid on the printer.

Except as specifically explained in this guide, do not attempt to service the printer

yourself.

Unplug the printer and refer servicing to qualified personnel under the following

conditions:

If the power cord or plug is damaged; if liquid has entered the printer; if the printer

has been dropped or the cabinet damaged; or if the printer does not operate normally

or exhibits a distinct change in performance. Adjust only those controls that are

covered by the operating instructions.

If you plan to use the printer in Germany, observe the following:

To provide adequate short-circuit protection and over-current protection for this

printer, the building installation must be protected by a 10 or 16 amp circuit breaker.

Printer parts marked with this symbol may be hot. Turn off the

printer and let it cool for a few minutes before you touch any printer

part marked with this symbol.

Important Safety Instructions