- ページ 3

カーエレクトロニクス Axxess AX-LR904のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Axxess AX-LR904 8 ページ。 Land rover freelander 2 (with m.o.s.t. 25 amplifier) data interface with swc & factory display retention2006-2014

ページを印刷する

INSTALLING THE AX-LR904 INTERFACE

With the key in the off position:

• Zip tie the chime speaker under the dash to a location where it will be heard clearly by the

driver, then route the harness to the radio location.

• Connect the chime speaker to the connector on AX-LR904 Interface labeled "To Speaker".

• Connect the AX-LR904 harness to the AX-LR904 interface.

• Remove the dust cover from fiber optic port in the AX-LR904 amplifier interface.

• Connect the factory fiber optic cable into the AX-LR904 amplifier interface.

• Connect the AX-LR904 harness to the AX-LR904 amplifier interface.

• Connect the M.O.S.T. jumper harness to the factory fiber optic cable from the display screen.

• Connect the AX-LR904 harness to the wiring harness in the vehicle. The Green 10-pin harness

will connect at the display screen. The Gray 14-pin harness will connect at the CD Drive.

• Connect the ASWC-1 harness to the ASWC-1 interface, and then to the AX-LR904 interface.

PROGRAMMING THE ASWC-1 INTERFACE

• Press and hold the Volume-Up button on the steering wheel.

• Turn the ignition on, the L.E.D. in the ASWC-1 interface will start flashing rapidly, which

means the ASWC-1 is looking for the vehicle and the radio.

Note: If the L.E.D. did not start flashing rapidly, press the reset button for 3 seconds, while

still holding the Volume-Up button.

• After a few seconds the L.E.D. should stop flashing rapidly, and then go out for

approximately 2 seconds.

• After approximately 2 seconds there will be a series of 7 Green flashes, some short, and

some long. The long flashes represent the wires that are connected to the ASWC-1. The 3rd,

4th, 5th, and 6th flashes should be longer.

Tip: Knowing this will help to troubleshoot, if need be.

• The L.E.D. will pause for another 2 seconds, and then flash Red up to 18 times depending on

which radio is connected to the ASWC-1. Refer to the L.E.D. feedback section for information.

• This is the end of the auto detection stage. Release from holding the Volume-Up button.

If the ASWC-1 detected the vehicle and the radio successfully, the L.E.D. will light up solid.

• Test the steering wheel controls for proper operation. Refer to the ASWC-1 instructions online

at axxessinterfaces.com for customizing the buttons, if so desired.

Continued on the next page

REV. 6/21/2018 INSTAX-LR904