- ページ 5

プリンター Epson 5700i - EPL B/W Laser PrinterのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Epson 5700i - EPL B/W Laser Printer 13 ページ。 Product information guide
Epson 5700i - EPL B/W Laser Printer にも: セットアップマニュアル (33 ページ), 仕様 (2 ページ)

Epson 5700i - EPL B/W Laser Printer ユーザーマニュアル
5. Remove the printer's side cover by lifting the clip and
sliding the side cover backward. Then lift the side cover
away from the printer.
1
2
3
6. Loosen the retaining screws securing the shield cover, and
remove the cover.
Caution:
Before you install the module, be sure to discharge any static
electricity by touching the printer's shield cover while it's still
attached to the printer (or touch any other part of the shield plate).
Otherwise, you may damage static-sensitive components.
7. Insert the SIMM module into the RAM slot at an angle,
making sure the pin numbers (either 1 or 72) of the slot and
the SIMM match.
1
2
9/99
8. Press the module forward until it clicks into place at a right
angle to the board. Do not apply too much force.
9. Replace the shield cover and tighten its screws.
10. Replace the printer's side cover by inserting the side cover's
hooks into the case's slots and sliding the side cover
forward.
2
11. Gently close the printer cover.
12. Plug the power cord back in and turn on the printer.
If an incorrect amount of memory is shown on the status
sheet, turn off the printer and review the steps above to make
sure you correctly installed the SIMM. If the amount of
memory is still incorrect, contact your dealer or a qualified
service person for assistance.
Note
:
The maximum amount of memory is 13MB. Even if a 16MB SIMM is
installed, only 13MB is accessible.
EPSON EPL-5700i
2
1
1
EPSON EPL-5700i
- 5