- ページ 3

プリンター Epson ActionNote 890のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Epson ActionNote 890 5 ページ。 Product support bulletin(s)
Epson ActionNote 890 にも：カートリッジ交換 (2 ページ), プログラミング説明書 (12 ページ), プログラミング手順 (1 ページ), インストール手順 (9 ページ)

tube clip so the tubes don't touch the bottom of the printer, and so the carts can reach far left and right with

out the tubes stopping the motion. This is important.

6. Clean the right section of the printer housing with alcohol, then install the second bracket on the right hand

edge of the housing so the tubing is in a straight line. Put the tubing into this small bracket. Now you are

ready to insert the tubes into the bottles. The position of the bracket opening can be either up or down. It

does not matter.

Set up the Bottles and Insert Tubes -

7. Set up the bottle tray next to the right hand side of the printer. The cartridges come with extra tube length.

Some of the tubing must be cut off of each tube. Un-web the tubes all the way back to the small tubing

bracket on the right hand edge of the printer. Trim each tube length so that the tube will make a turn into the

bottle with out rising up. There must be 3

in order.... Y-PM, M-PC, K-C from front to back. You just want to have a neat orderly tube arrangement.

Cut the ends of the tubes on a 45 degree angle so they have a point on them. After you cut the tubes to

length, use a black marker and make a mark on each tube 3

tubes through the larger hole in the center of the cap until the black mark is just inside the cap. Don't cut the

tubes too short.

Ready to Turn Power On -

8. Move the cartridges, by hand to the far right side of the printer until they stop. Plug the printer power plug

back into the wall. If the power light on the front panel is not on, press it in to turn on the power. The printer

should make some quiet noises and the cartridges may move left to right. There should NOT be a red light

on the front panel. THIS IS IMPORTANT. If there is a red light, this means the chips on the front of the

cartridges are not making contact with the printer. See the troubleshooting section of our website if this

happens.

Now the tubes are all attached and inserted into the bottles. Make sure the tubes are not restricting the

motion of the cartridges. Add more slack if they are. When the printer stops making noise, you are ready to

start printing.

Let Ink Begin to Fill Tubes -

9. Run 3 cleaning cycles. Print a couple of copies of purger6.tif, found on the diskette.

begin to climb up the tubes. They will not all rise at the same rate. If you have banding or incomplete

printing, run 3 more cleaning cycles and nozzle checks. As soon as you have a good nozzle check, you are

ready to start using the system. As you print, the inks will continue their climb until they reach the cartridge.

Don't worry if the inks seem to be moving slowly, they will all get to the cartridge eventually. It is not

necessary to wait until the inks have filled the tubes. You can begin printing as soon as you have a good

nozzle check.

inch of tubing inside the bottle. The bottles should be arranged

inch from the end of the tube. Insert the

The inks should