- ページ 7

I/Oシステム DigiDesign AI16のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。DigiDesign AI16 12 ページ。 Analog input card for mix rack

Chapter 2: Installing the AI16 Card

The AI16 Analog Input Card is installed in Mix Rack and is

connected to the appropriate Mix Rack ribbon cable. Mix Rack

supports a total of three AI16 Cards. In its base configuration,

input slots A, B, and C contain an AI16 Card.

If you want to remove an AI16 Card from the Mix Rack, see

"Removing an AI16 Card" on page 4.

Your Mix Rack has three available input slots: slots A, B,

and C. You must install the AI16 Card in one of these three in-

put slots.

To install an AI16 Card:

Shut down the VENUE system, and turn off power to the

Mix Rack.

Disconnect all cables from Mix Rack.

Remove Mix Rack's front panel cover by unscrewing its

mounting screws (#1 Phillips).

Mounting screws (remove all)

Mix Rack front panel

On Mix Rack's back panel, locate input slot A, B, or C.

Mix Rack back panel

If you are replacing an AI16 Card, you must first remove

one of the cards. See "Removing an AI16 Analog Input

Card" on the next page, then proceed with these instruc-

tions.

Remove the card from its packing material. Hold the card by

its edges.

Gently slide the card into the input slot.

When the card is seated in its slot, use the captive thumb-

screws to secure the card to Mix Rack's chassis in the back of

Mix Rack.

Secure the card to the front panel of Mix Rack using the four

mounting screws you removed earlier.

Find the ribbon cable that corresponds to the input slot in

which you have installed the AI16 Card.

Mix Rack contains 5 ribbon cables that connect to the Input

and Output Cards. The are aligned vertically. The bottom

ribbon cable corresponds with input slot A, the next with

input slot B, the next with input slot C, the next with out-

put slot D, and the top ribbon cable corresponds with out-

put slot E.

Input slots

A, B, & C

Chapter 2: Installing the AI16 Card 3