- ページ 10
プリンター Epson AcuLaser C8600のPDF クイック・リファレンスをオンラインで閲覧またはダウンロードできます。Epson AcuLaser C8600 23 ページ。 Epson aculaser c8600: specifications
Epson AcuLaser C8600 にも： セットアップマニュアル (44 ページ), 仕様 (1 ページ)
ページを印刷する
Time exceeded
Paper was forcibly output (blank sheet
printing) as the print data did not arrive in
time even though paper was pre-fed.
Toner Cart Out
One or more toner cartridges are not
installed in the printer.
Install the cartridges. See "Toner Cartridge"
in the Reference Guide.
Turn Paper XXX
Paper is loaded in the wrong orientation in
the XXX cassette. Remove the paper stack
from the standard lower cassette, turn it by
90 degrees, and reload it with the long edge
first.
Unable Clear Error
The printer cannot clear an error message
because the error status still remains. Try
solving the problem again.
Unit B Open
The fuser unit is open. The error
automatically clears itself when the fuser
unit is closed properly.
Unit C Open
The paper path unit is open. The error
automatically clears itself when the paper
path unit is closed properly.
Unit G Open
The optional Duplex Unit's main unit is
open. The error automatically clears itself
when the Duplex Unit's main unit is closed
properly.
EPSON AcuLaser C8600 Quick Reference
Warming Up
The printer is warming up.
Waste T Box Nearfull
The waste toner collector is nearly full of
toner. You can continue to print until the
Replace Waste T Box error message
appears, but early replacement is
recommended to maintain high print
quality. See "Replacing the waste toner
collector" in the Reference Guide.
Worn Fuser
This message indicates that the fuser unit is
near the end of its service life. Turn the
printer off, then replace the fuser unit with a
new one. Contact your dealer.
To clear this warning message and continue
printing, select Clear Warning from the
control panel's Reset Menu. See "How to
access the control panel menus" for
instructions.
Worn Photoconductor
This message indicates that the
photoconductor unit is near the end of its
service life. You can continue to print until
the Replace Photocondctr error message
appears, but early replacement is
recommended to maintain high print
quality.
To clear this warning message and continue
printing, select Clear Warning from the
control panel's Reset Menu. See "How to
access the control panel menus" for
instructions.
Write Error ROM A/Write Error ROM P
This message indicates an internal error in
the printer. Reset the printer. If this error
persists, consult your dealer.
Status and Error Messages (7/8)