- ページ 9

電動工具 Arcflash Labs EMG-01 BetaのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Arcflash Labs EMG-01 Beta 16 ページ。 8 stage igbt coilgun

2.7 Magazine

- The EMG-01B uses a similar magazine retaining mechanism to the SGP-35. Inserting the

magazine should be done in a fluid motion. There is no switch or button required to insert

or remove the magazine, a ball detent retainer holds the magazine securely in place.

The EMG-01B uses a proprietary magazine design and retaining mechanism which was

designed to accommodate an 18-round 3D-printed magazine (the MG18). The magazine uses a

constant pressure spring to store up to 18 0.25x0.75" projectiles. The magazine socket on the

EMG-01B is compatible with the SG18 magazines used in the SGP-34/35 accelerators.

Unfortunately it is not backward compatible with the MG-20 or MG-9-CS magazines

used by the EMG-01A.

2.8 Capacitors

- The EMG-01B contains 10 large 33mF capacitors capable of storing up to 100J of

combined energy.

The EMG-01B contains a large bank of electrolytic capacitors (330,000 uF total

capacitance) – at the time of construction these are the highest density electrolytic capacitors

in production. They are capable of delivering up to 300A burst current at 25V and storing over

100J of energy.

The capacitors require approximately 6 seconds to charge during power-up and 4

seconds to discharge during power-down. To power down the gun we recommend the

following procedure: 1) set the microcontroller to "SAFE", 2) switch the Main Switch to the

DISCHARGE (FORWARD) position, 3) remove the Main Fuse from its socket – this immediately

removes the battery from the circuit, 4) remove the magazine from the gun, verify that there is

no round still remaining in the barrel, and 5) wait for ALL LEDs to extinguish before removing

the battery.

The red LED in the electronics bay indicates the state of charge on the capacitors. If the

red LED is active, the capacitors are charged.

9 |

P a g e