- ページ 3

超音波ジュエリークリーナー Arch Environmental Equipment Saber MaxのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Arch Environmental Equipment Saber Max 4 ページ。 Belt cleaner

STEP 7

Put the frame and blade assembly (Items 3& 4) inside the chute, and slide the tensioner

pipes (Item 1) through the holes previously cut in the structure. Then slide the tensioners

(Item 2) onto the tensioner pipes. The bushing inside the tensioner hub should fit over

about 1" of the square section of the pipe. Next, level the cleaner in relation to the head

pulley. Verify the "Z" dimension by slipping the urethane installation rings onto the pipes.

Once the "Z" dimension has been verified, tack-weld the tensioners into place. Set the

cleaner blade against the belt and insert both tensioner pins into both outer hubs on the

tensioners. Ensure that the square section of the tensioner pipe is located within the

welding hub of both tensioners. Tighten the set screws on the mainframe and complete

welding on the tensioners (4 - 2 " (50.8 mm) welds on each tensioner is enough). Pull the

pins again to check if the cleaner rotates freely in the hubs. If it does not, realign the

tensioners until the cleaner rotates freely.

STEP 8

Finally, starting with one side pull the tensioner pin and rotate the tensioner away from the

head pulley, until the next hole shows (Figure 4) in the tensioner hub. Reinstall the pin.

Repeat this process for the other tensioner.

That's it!