On when the printer is in top-of-form
TOP OF FORM
mode.
Indicates the selected pitch (10, 12, 17).
PITCH
On when the front tractor is selected. The
PAPER SELECT
light is green when paper is loaded (even
FRONT
if the paper is in the standby position),
and red when the tractor is out of paper.
PAPER SELECT
On when the rear tractor is selected. The
light is green when paper is loaded (even
REAR
if the paper is in the standby position),
and red when the tractor is out of paper.
Buttons
Stops or starts printing, if print data is
PAUSE
currently in the input buffer.
LF/FF/LOAD
LF advances paper one line at a time. To
feed paper one line, press this button once.
FF advances the paper to the top of the
next page. To use this feature, press and
hold the button for about one second.
LOAD loads paper on the push tractor of
the selected paper path when no paper is
currently loaded.
Feeds the paper to the printer's tear-off
TEAR OFF
edge and puts the printer in tear-off mode.
If the perforation of your paper does not
align exactly with the printer's tear-off
edge, use the MICRO FEED buttons to
adjust the tear-off position.
MICRO FEED
Adjusts the paper position including the
top-of-form and tear-off positions. The
forward MICRO FEED button (^)
advances the paper in 1/216-inch
increments and the backward MICRO
FEED button (v) feeds the paper backward
in 1/216-inch increments.
Enables the top-of-form mode, so that the
TOP OF FORM
top-of-form position can be adjusted using
the MICRO FEED buttons. This button
functions only when the paper is loaded
into the printer using the LF/FF LOAD
button and the printer is in pause mode.
PITCH
Selects a character pitch of 10, 12, or 17 cpi.
Selects the front or rear tractor. If you have
PAPER SELECT
been using paper loaded on one tractor,
FRONT/REAR
first remove the printed output before
pressing this button to switch the tractor.
When you switch between tractors, the
paper already loaded in the printer is fed
backward to the standby position and the
paper on the newly selected tractor is
loaded.
7HVWLQJýWKHý3ULQWHU
You can use the built-in self-test to make sure the printer is
working correctly. The self-test checks the following:
Control circuit
Printer mechanism
Print quality
Before performing the self-test, you need to load paper.
Loading paper onto the front tractor
1. Open the printer's front cover by lifting the middle of its
bottom edge up until it locks in place.
2. Release the sprocket lock levers on both the right and left
sprocket units by pulling each lever down.
3. Slide the left sprocket unit all the way to the left. Lock it
into place by pushing the sprocket lever up.
4. Slide the right sprocket unit to approximately match the
width of the paper. (Do not lock it into place yet.)
5. Slide the two paper supports so that they are spaced evenly
between the sprocket units.
êîìèîäé
(3621ý');ðèíííò
(3621ý');ðèíííòýðýè
ページを印刷する