- ページ 4

照明器具 ARCHIPELAGO LIGHTING LEMXのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ARCHIPELAGO LIGHTING LEMX 5 ページ。

LEMX - Installation Guide

Wall Mount: LEMX-Sx

1. Knock out the proper hole pattern in the back plate

to mount to a standard junction box. Place a support on

either side of the knockouts to be removed and then

knock out with a screwdriver (Fig. A).

2. Using a flat screwdriver, remove the front cover, remove

and discard the canopy kit.

3. Feed excess wires into the junction box.

4. The system can accept input voltages of 120 VAC or

277 VAC. Connect the black/red wire (line voltage) and the

white wire (neutral) leads to the building utility. Connect

the green ground.

5. Using the junction box screws to mount spider plate

onto junction box (Fig. C).

6. Mount the unit securely to the junction box using the

junction box screws.

7. Snap the EXIT plate to the unit (Fig. D).

8. If the EXIT needs to point to certain direction,

arrow can be removed.

Ceiling Mount: LEMX-Sx

1. Using a flat screwdriver, remove the front cover, remove

and discard the canopy kit.

2. Feed excess wires into the junction box.

3. The system can accept input voltages of 120 VAC

or 277 VAC. Therefore connect the black/red wire (line

voltage) and the white wire (neutral) leads to the building

utility. Connect the green ground.

4. Using the junction box screws to mount spider plate

onto junction box.

5. Install the canopy to junction box.

6. Mount the unit securely to the canopy.

7. Snap the EXIT plate to the unit.

Headquarters: 4615 State Street, Montclair, CA 91763

Production Center: 7345 Syncamore Canyon Blvd, Riverside, CA 92508

1. Fig. A

6, 7. Fig. D

2, 3, 4. Fig. B

5. Fig. C

8. Fig. E

2, 3, 4.

archipelagolighting.com

+1(866) 912-3220