- ページ 3

ランタン CREE LIGHTING KBLのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。CREE LIGHTING KBL 6 ページ。 Led, universal hook and cord or pendant mount

ページを印刷する

Reflector

Screw

Heatsink

ELECTRICAL CONNECTIONS

STEP 1:

Make the following Electrical Connections:

a. For 120/277/347V connect the black fixture lead to the

voltage supply or Hot 1 (for 208/240/480V wiring).

b. For 120/277/347V connect the white fixture lead to the

neutral supply or Hot 2 (for 208/240/480V wiring).

c. Connect the green or green/yellow ground lead to the green

wire position of the terminal block.

STEP 2:

For Dimming make the following Electrical Connections:

NOTE: The incoming signal cable needs to pass through the 1/2"

knockout shown in Figure 3 on page 2.

d. If 0/1-10V Dimming is used, connect the violet lead to the

supply positive dimming lead. If dimming is not being used

ensure to cap off the violet lead.

e. If 0/1-10V Dimming is used, connect the gray lead to the

supply negative dimming lead. If dimming is not being used

ensure to cap off the gray lead.

3 of 6

Hinge Retainer

Frame Hinge

Mounting Ring

Reflector

Lens with V-band

Safety Cable

STANDARD REFLECTOR:

STEP 1:

Loosen the (4) screws, shown in Figure 5, at least 0.1 inch from the

heatsink.

NOTE: The view in Figure 5 is of the underside of the luminaire.

STEP 2:

Bring trim into housing and line up the (4) screws from Step 1, with the

keyhole slots on the reflector.

STEP 3:

Rotate trim, turn clockwise and tighten the (4) screws from Step 1.

Mounting Lens or Wire Guard To Aluminum Reflector

STEP 1:

Secure the hinge retainer and frame hinge to the reflector using

supplied screw and lock nut. See Figure 6.

NOTE: Reflector is pre-punched at position of this installation.

STEP 2:

Swing the wire guard into place and secure to the reflector with the

attached spring latch. See Figure 6.

Mounting Lens or Wire Guard To Prismatic/ Polycarbonate

Reflector

STEP 1:

Place lens or wire guard onto the bottom of reflector, and place V-band

around lens and reflector. See Figure 7.

STEP 2:

Secure lens or wire guard to reflector by tightening screw on V-band.

See Figure 7.

INSTALLING SAFETY CABLE

NOTE: Safety Cable is sold separately as an accessory, please refer

to installation sheet in safety cable packaging for complete installing

instructions.

STEP 1:

Attach one end of the safety cable through the fin of the heatsink. See

Figure 8.

STEP 2:

Attach other end of the safety cable to mounting surfaces using

customer supplied hardware.

LINE

OR HOT 1

GREEN

GROUND-GREEN

NEUTRAL

NEUTRAL-WHITE

OR HOT 2

VIOLET

GREY

LUMINAIRE

LINE-BLACK

DIM (+) VIOLET

DIM (-) GREY

LPN00513X0001A4_D