- ページ 4

ランタン CREE LIGHTING ZR22RKのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。CREE LIGHTING ZR22RK 5 ページ。 Led retrofit troffer kit, standard and emergency luminaires

ページを印刷する

FCC NOTICE

CAUTION: Changes or modifications not expressly approved could void

your authority to use this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits

for a Class A digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area

is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

CAN ICES-005 (A)/NMB-005 (A)

EMERGENCY DRIVER CHECK

NOTE: For short-term testing of the emergency function, the battery

must be charged for at least one hour. The emergency driver must be

charged for at least 24 hours before conducting a long-term test.

ELECTRICAL CONNECTIONS

FOR ZR22RK and ZR24RK :

STEP 1:

Make the following Electrical Connections:

a. Connect the black fixture lead to the voltage supply Line

position, Hot.

b. Connect the white fixture lead to the neutral supply

position.

c. Connect the green ground lead to the incoming ground

lead from the conduit or screw the green ground lead

to the existing troffer pan if the safety ground is made

through the pan on the existing troffer.

d. If 0/1-10V Dimming is used, connect the violet lead to

the supply positive dimming lead. If dimming is not being

used ensure to cap off the violet lead.

e. If 0/1-10V Dimming is used, connect the grey lead to the

supply negative dimming lead. If dimming is not being

used ensure to cap off the grey lead.

4 of 5

STEP 1:

When AC power is applied, the charging indicator light is illuminated,

indicating the battery is being charged. When power fails, the

emergency driver automatically switches to emergency power,

operating the LED array. When AC power is restored, the emergency

driver returns to the charging mode.

STEP 2:

Although no routine maintenance is required to keep the emergency

driver functional, it should be checked periodically to ensure that it is

working. The following schedule is recommended:

• Visually inspect the charging indicator light monthly. It should be

illuminated.

• Test the emergency operation of the fixture at 30-day intervals for

a minimum of 30 seconds. When the test switch is depressed, the

LED array should operate.

• Conduct a 90-minute discharge test once a year. The LED array

should operate for at least 90 minutes.

If the luminaire fails any of these checks, consult service personnel.

REFER ANY SERVICING INDICATED BY THESE CHECKS TO QUALIFIED

PERSONNEL

EMERGENCY DRIVER AND AC DRIVER MUST BE FED FROM THE

SAME BRANCH CIRCUIT

LINE 1

GREEN

NEUTRAL

VIOLET

GREY

LUMINAIRE

LINE-BLACK

GROUND-GREEN

LINE-WHITE

DIM (+) VIOLET

DIM (-) GREY

LPN00429X0001A3_B