- ページ 3

スピーカー ARCHITETTURA SONORA SPHEREのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。ARCHITETTURA SONORA SPHERE 4 ページ。

ページを印刷する

5 >

the Sphere, positioning it resting at on the

perimeter acoustic dumper as shown in the

image. Be sure to place it with the 4-wire

cable facing up. Place the second sound-ab-

sorbing circular cap on top of it.

6 >

ange, overturned with the connectors

visible and insert the silicone gasket over

the coaxial basket. Stagnate the connec-

tors and the quadripolar cable and then

weld the contacts (welder temperature

400°C) on the coaxial, quickly enough to

avoid thermal damage to wires and internal

connections of the driver. Be sure to

remember the colors of the phases.

(Brown > +Woofer; Green > -Woofer;

Yellow > +Tweeter; White > -Tweeter)

2.1 > Crossover Board Assembly:

4 >

Close the box cover tightening the four star screws.

5 >

Check the cover tightness (accurate resting on its seat) and the cable glands (making sure cables

have no clearance or air leakage).

3.0 > Possible Cases.

3.1 > Sphere Base Replacement:

1 > 6

Follow steps

of "1.0 Disassembly Procedure" and then steps

3.2 > Coaxial Speaker Replacement:

1 > 3

Follow steps

of "1.0 Disassembly Procedure" and then steps

3.3 > Crossover Board Replacement:

1 > 6

Follow steps

of "1.0 Disassembly Procedure", then steps

Crossover Board Assembly" and nally steps

3.4 > Sphere Body Replacement:

1 > 6

Follow steps

of "1.0 Disassembly Procedure" and then steps

Insert the crossover box "candy"inside

Place the coaxial over the inner

1 >

2 >

3 >

2 > 7

of "2.0 Assembly Procedure"

bipolar

cable

groove for

cable on body

acoustic

dumper ring

Schnorr

washer (L)

Place the board inside the box and secure it to the box by screwing the four

star screws (X), paying attention not to force the plastic thread.

Arrange the internal wires according to the attached image, in order to avoid

inappropriate contacts between wiring and crossover components.

Solder the six connection points respecting the colors of the polarities

(welder temperature 400° C).

1 > 7

of "2.0 Assembly Procedure"

6 > 7

of "2.0 Assembly Procedure"

1 > 3

of "1.1 Crossover Board Removal", steps

1 > 7

of "2.0 Assembly Procedure"

quadripolar cable

acoustic dumper

crossover box

7 >

Overturn the coaxial matching the

holes in the basket with the holes in the

inner

ange. Position the protecting

frame on top of it, still matching the

holes, place the 4 M5X30 screws and

the "Schnorr" (L) washers in the holes of

the frame and using the Allen key #3 (B)

turn the screws counter-clockwise until

you hear a click that indicates the

correct insertion of the rst thread of the

screw in the threaded seat. Then

tighten the screws by turning clockwise

crosswise (always tighten the screw

opposite to the previous one) until you

start feeling resistance.

white

brown

yellow

brown

green

white

1 > 5

of "2.1

perimeter