- ページ 5
アンプ ARCHITETTURA SONORA ASM2EVOのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ARCHITETTURA SONORA ASM2EVO 14 ページ。
ページを印刷するAC Mains Power Cable >
NOTE: Turn off the AC power switch before connecting AC power.
Connect the AC mains plug to a suitable AC mains outlet.
Orient the IEC connector with the connector prongs in the socket,
then push the connector rmly into the IEC socket until fully seated.
The high current drain of the AS ampli ers demand the use of an adequate
AC connector. The cord supplied with the ampli er has the required characteristics.
In case it is unavailable or needs to be replaced, choose a replacement cable with equivalent speci cations, labeled with
the safety certi cation marking in force in the country of installation.
When installing the unit in places accessible to the general public, the cable insulation must be of the re-retardant,
low-smoke zero-halogen (LSZH) type. Country-speci c technical regulations may apply. We suggest consulting a
quali ed supplier for the cable selection.
In case the mains plug needs to be replaced, have it installed by a quali ed technician, who should select a plug with the proper speci cations
and labeled with all suitable safety certi cation markings in force in the country of installation.
4. General Informations
Front Panel
A.
Master volume control.
B.
Standard rack handles holes (racks mounting brackets provided).
C.
Dual-color Stand-By power LED.
D.
Dual-color Status power LED.
E.
Power button.
Rear Panel
F.
RCA unbalanced inputs and LINK outputs.
Channel's gain adjustment trimmers: they are covered by a protective cover and the adjustment are done (if required) at the initial
G.
set-up. They are not intended as user-accessible controls. The user may adjust the master volume level using the front panel's
control.
H.
Data Prg connector for DSP programming (accessible only by trained personnel).
I.
Pro/Home switch
L.
Power ampli ers' output Neutrik SpeakON connectors for wiring the sonic modules.
M.
AC mains inlet for power cable.
Mains power switch.
N.
Connect AC power to the IEC socket on the back of the ampli er.
5
STAND-BY
POWER
STATUS
AS - MULTI-CHANNEL POWER AMPLIFIER