- ページ 2
アンプ Creek Audio EVOLUTION 50AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Creek Audio EVOLUTION 50A 13 ページ。 Integrated amplifier
Creek Audio EVOLUTION 50A にも： ユーザーマニュアル (8 ページ), 取扱説明書 (17 ページ)
ページを印刷する
Thank you for purchasing a Creek Audio EVOLUTION 50A Integrated Amplifier. You are
now in possession of a State of the Art performance product. The functions and operation
of this integrated amplifier are simple, however, the following notes are provided to explain
all aspects of its design and use.
Although this User Manual is intended to provide the latest instructions for use, it is possible
that a later version may be available to download from the Creek website.
Please check at www.creekaudio.com
Go to the EVOLUTION 50A product page and click on the
tab marked Instructions.
Now please take a few minutes to register your new EVOLUTION 50A on the Creek website
at www.creekaudio.com/register.php.
UNPACKING AND LOCATING THE AMPLIFIER
When unpacking the EVOLUTION 50A please keep all the packing material in a safe place
for possible future use. In the carton there is a separate mains cable suitable for connect-
ing to the mains supply in the country of use. You will also find a remote control unit and
batteries.
Make sure that the EVOLUTION 50A is on a suitable table, shelf or hi-fi equipment cabi-
net.
It is important to allow good ventilation to the heat-sinks inside the case. Avoid obstruction
of the ventilation slots on the top and bottom of the EVOLUTION 50A. It may be necessary
to place the EVOLUTION 50A on the top of other equipment, or a separate shelf to allow
for this. Do not place it at the bottom of a stack of equipment, as it may get too hot and
switch-off, with an over-temperature warning on the display.
MAINS CONNECTION
IMPORTANT: Before connecting the amplifier to the mains supply, please check that the
voltage selector switch on the rear of the amplifier is set to the correct supply voltage for
your region. Permanent damage can be caused by using an incorrect setting.
The IEC socket end of the supplied cable should be firmly inserted into the connector on
the rear panel. Connect the mains plug to your AC outlet. Do not overload the mains outlet
with too many plugs or adaptors. The high quality performance of the 50A may be impaired
if the electrical supply to it is in poor condition. If in doubt, consult your hi-fi dealer, or a
qualified electrician for advice.
The Mains Input connector on the rear panel is also fitted with a fuse in a pull-out drawer.
The value of the 5 x 20mm cartridge fuse is clearly stated (T5AL 250V) next to the socket,
on the rear panel. This means it is a 5 Amp Time-lag (Anti-surge) type fuse, rated at 250V.
Always replace the fuse with one of identical rating to prevent the risk of fire!
Page: 1