- ページ 4
ボート Creek Company ODC JETPACKのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Creek Company ODC JETPACK 4 ページ。
ページを印刷するODC JETPACK™
Your ODC Outdoor Discovery Craft
IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC JETPACK
RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY
DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US VIA
HIN
(HULL IDENTIFICATION NUMBER) IS LOCATED ON RIGHT SIDE OF SEAT SUPPORT FRAME
MEMBER AND ON RIGHT SIDE OF CARGO DECK FRAME (SEE FIGURE 1)
1. Always wear a US Coast Guard approved personal flotation device when in your ODC JETPACK
2. Never float alone.
3. Always check your ODC JETPACK
before you use your craft.
4. Never use your craft if you suspect the Air Bladders, Frame, Oar components, outer skin or stitching has been damaged.
5. Never over inflate your ODC JETPACK
6. Never use your ODC JETPACK
1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat Valve
Assembly and repeat Pontoon inflation instructions.
2. Do not store your ODC JETPACK
3. If you are leaving your ODC JETPACK
pressure inside the Pontoons to a dangerous level. Let some of the air out of the Pontoons if the craft will be out of the water
in the sun for any length of time, or if it is stored in a vehicle, etc.
4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC JETPACK
a low elevation to a high elevation, be sure to let some of the air out of it.
5. For short term storage, we recommend you let some air out of your pontoons.
6. For long term storage, we recommend you make sure your ODC JETPACK
the sunlight in a cool dry area. Do not store your wet ODC JETPACK
frame and other component damage.
7. Repairing Bladder, use enclosed Patch Kit. Identify puncture. Fully deflate Bladder. Clean and dry area around puncture.
Apply glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to dry,
before inflating.
8. Note: Metal parts may rust and are not covered under warranty.
9. We recommend the use of electric trolling motors only on your ODC JETPACK
10. Do not use the cargo deck as a standing platform. It is not designed for this
and may break if used in this capacity.
Accessories are available for your ODC JETPACK
The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477
970-879-5221 • fax 970-879-7577 • email: [email protected] • Made in China
All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to
the original owner. This does not cover damage due to misuse or normal wear and tear.
O O U U T T D D O O O O R R D D I I S S C C O O V V E E R R Y Y C C R R A A F F T T
Please follow inflation instructions and warnings carefully.
E-MAIL AT [email protected]
Warning:
Please read and follow carefully.
™
Air Bladders, Frame, Oar components, outer skin and stitching for possible damage
™.
™
without the air chambers fully inflated.
CARE AND MAINTENANCE:
™
in direct sunlight.
™
out in the sun for any amount of time, be aware that the heat can increase the
or visit the Creek Company Store at www.CreekCompany.com
Specifications and other details subject to change without notice.
™
is designed to give you many years of service.
™
is completely dry, deflated and stored out of
™
in freezing temperatures as this may result in
™
.
™
. Ask for them where you bought your ODC JETPACK
T T M
M
™
PLEASE DO NOT
™
.
™
from
™
,