- ページ 5

コントローラー ABB vital 1のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。ABB vital 1 20 ページ。 Safety controller
ABB vital 1 にも：マニュアル (14 ページ)

Overview

Vital 1 is a safety module that generates and monitors a dynamic safety signal, which makes it possible to achieve

a redundant safety system that complies with PL e, category 4 using only a single dynamic safety signal. This

allows quick and straightforward installation of the entire safety system.

The safety modules in the Vital series are intended for use with safety sensors designed for the dynamic safety

circuit, such as the non-contact safety switch "Eden", the safety light beam "Spot" and similar sensors that can be

connected directly to Vital 1. Other safety sensors can easily be connected to the dynamic safety circuit through an

adaptor unit. Adaptor units in the "Tina" series are available for a lot of different safety sensors.

Vital 1 has two safe relay outputs (both outputs consists of two relays connected in series) and a non-failsafe

information output with customizable functionality.

Other features include:



Manually supervised or automatic reset



LED indication of:

Power

Dynamic signal status

Relay output status



Detachable connection blocks

NB: Refer to section Installation precautions for important precautions when using safety light beam "Spot" together

with Vital 1.

Warning!

Carefully read through this entire manual before using the device.

The devices shall be installed by a trained electrician following the Safety regulations, standards and the Machine

directive.

Failure to comply with instructions, operation that is not in accordance with the use prescribed in these instructions,

improper installation or handling of the device can affect the safety of people and the plant.

For installation and prescribed use of the product, the special notes in the instructions must be carefully observed

and the technical standards relevant to the application must be considered.

In case of failure to comply with the instructions or standards, especially when tampering with and/or modifying the

product, any liability is excluded.

2TLC172156M0201, rev. C

2016-07-04