- ページ 7
コントロールユニット Digikeijs DR4088GNDのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Digikeijs DR4088GND 15 ページ。 Feedback module
Digikeijs DR4088GND にも： 取扱説明書 (11 ページ), マニュアル (8 ページ), 取扱説明書 (12 ページ)
ページを印刷する
DR4088LN-CS / GND / OPTO
3.1.2 Programming with any control panel or app.
1.
Connect the central unit to the DR4088LN-xx to be programmed.
2.
(Normally it is not necessary to disconnect other feedback modules from LocoNet®.
3.
First the DR4088LN-xx must be assigned the start address.
4.
Open the turnout control panel which contains the desired start address which the DR4088LN-xx is to receive.
5.
Depending on which control panel, handset controller or app is used for programming, either the corresponding turnout or the corresponding turnout control
panel must be called at the control panel. With some App's a corresponding turnout with the desired address must be created.
6.
Press the programming button on the DR4088LN-xx. The green LED starts flashing to indicate that the DR4088LN-xx is in programming mode.
7.
To assign the start address, switch the turnout address e.g. 1 once (i.e. only red or green!).
8.
The green LED on the DR4088LN-xx now flashes in a different cycle and signals that the DR4088LN-xx next expects the number of feedback signals. The num-
ber of feedbacks is again sent to the DR4088LN-xx via a switch command.
9.
Normally, if no DR4088 (S88) is connected to the DR4088LN-xx, this is address 16 .
10.
At the central station, at the handset controller or in the app, call up the turnout control panel which contains the address corresponding to the number of
feedback signals.
11.
Normally this is the address 16. Again, only red or green switching applies.
12.
The DR4088LN-xx automatically terminates the programming mode and is now programmed with the start address and the number of feedbacks..
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-04-21
P 7