- ページ 4

コンピュータ・ハードウェア Digilent Basys 2のPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Digilent Basys 2 12 ページ。 Fpga board

Basys2™ FPGA Board Reference Manual

User I/O

Four pushbuttons and eight slide switches are provided for circuit inputs. Pushbutton inputs are normally low and

driven high only when the pushbutton is pressed. Slide switches generate constant high or low inputs depending

on position. Pushbuttons and slide switches all have series resistors for protection against short circuits (a short

circuit would occur if an FPGA pin assigned to a pushbutton or slide switch was inadvertently defined as an

output).

Eight LEDs and a four-digit seven-segment LED display are provided for circuit outputs. LED anodes are driven from

the FPGA via current-limiting resistors, so they will illuminate when a logic '1' is written to the corresponding FPGA

pin. A ninth LED is provided as a power-indicator LED, and a tenth LED (LD-D) illuminates any time the FPGA has

been successfully programmed.

4.1

Seven-segment display

Each of the four digits of the seven-segment LED display is composed of seven LED segments arranged in a "figure

8" pattern. Segment LEDs can be individually illuminated, so any one of 128 patterns can be displayed on a digit by

illuminating certain LED segments and leaving the others dark. Of these 128 possible patterns, the ten

corresponding to the decimal digits are the most useful.

The anodes of the seven LEDs forming each digit are tied together into one common anode circuit node, but the

LED cathodes remain separate. The common anode signals are available as four "digit enable" input signals to the

4-digit display. The cathodes of similar segments on all four displays are connected into seven circuit nodes labeled

CA through CG (so, for example, the four "D" cathodes from the four digits are grouped together into a single

circuit node called "CD"). These seven cathode signals are available as inputs to the 4-digit display. This signal

connection scheme creates a multiplexed display, where the cathode signals are common to all digits but they can

only illuminate the segments of the digit whose corresponding anode signal is asserted.

A scanning display controller circuit can be used to show a four-digit number on this display. This circuit drives the

anode signals and corresponding cathode patterns of each digit in a repeating, continuous succession, at an update

rate that is faster than the human eye response. Each digit is illuminated just one-quarter of the time, but because

the eye cannot perceive the darkening of a digit before it is illuminated again, the digit appears continuously

illuminated. If the update or "refresh" rate is slowed to a given point (around 45 hertz), then most people will

begin to see the display flicker.

Other product and company names mentioned may be trademarks of their respective owners.

Page 4 of 12