- ページ 4
対流式オーブン Cres Cor CO151XWUA5DE2401のPDF インストレーション、オペレーション、メンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Cres Cor CO151XWUA5DE2401 15 ページ。 Humidity convection ovens
ページを印刷するConvection
Humidity Oven
Page 4 of 14
Rev. 4 (6/15)
HOW TO USE ROAST-N-HOLD CONTROL:
*Push the lighted switch on the control panel; the oven
will start heating and stay in HOLD mode .
*The display will read "LOTPR" (low temperature)
below 140°F . (60°C .) .
NOTES: Preheat for one (1) hour after start up before
loading the food for best results when
retherming or cooking heavy loads .
If a power outage occurs or the cabinet is shut
off during a cook cycle, when it is turned on
again all lights on the control will flash to
indicate a disruption . Control will resume
the last cook cycle used . Press any button
to stop the blinking .
If your model does not have a food probe, continue to
section "-DE OVENS" below.
If your model has a food probe,
skip to section "-DX OVENS" on page 5.
-DE OVENS:
Cooking:
1 . Press the COOK button .
2 . Turn the control knob to the desired cooking
temperature between 180°F (82°C) and 350°F (176°C) .
3 . Push the knob to set the temperature .
4 . The control automatically switches to allow you to set
HOLD temp . (Continue to step 1 below) .
Holding:
(To use as holding cabinet only, skip steps 1-4 above and
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
FL-2373
OPERATING INSTRUCTIONS
5925 Heisley Road • Mentor, OH 44060-1833
press HOLD button . Complete steps 1-3 below .)
1 . Turn the control knob to the desired holding
temperature between 80°F (26°C) and 220°F (104°C) .
2 . Push the knob to set the temperature .
3 . The control automatically switches to allow you to set
cook time .
Setting the Timer:
1 . Turn the control knob to the desired hours/minutes .
2 . Push the knob to set the time .
3 . The control automatically switches to PREHEAT
mode and will display "PrEHt"
Running the Cycle:
1 . The control will flash "PUSH StArt" after the cabinet
has preheated to the set temp and the alarm will sound .
NOTE: A short beep will occur every 90 seconds as
a reminder . This can be turned off in the user menu by
holding the knob and the TIME buttons together for
5 seconds, then scrolling to "PSrE", changing "y" to
"n", scrolling to "End", and pushing the knob to set .
2 . Load foods into oven and close the door .
3 . Push the START button to begin the Cooking process .
Display will change between the setpoint temperature
and the countdown of the timer .
4 . The alarm will sound after the time is done and the
oven will switch back into HOLD mode . The timer
will now count up, showing how long the food has
been holding .