- ページ 3
錠前 Digilock DCR1-ATV1のPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Digilock DCR1-ATV1 4 ページ。 Rfid cam locks advanced security, shared use
ページを印刷するFor Lost or Stolen Keys
For a lost or stolen Programming Key:
The lost/stolen Programming Key will continue to operate the lock(s) until it is replaced. Immediately order a Replacement
Programming Key from your Digilock Product Representative. Once received, follow enclosed instructions to set up the lock(s) to
operate with the Replacement Programming Key.
For a lost or stolen Manager Key(s):
Lost/Stolen Manager Key(s) will continue to operate the lock(s). To prevent the lost/stolen Manager Key(s) from operating the
lock(s), erase all registered Manager Key(s) and register only the remaining Manager Key(s).
a.
Collect all remaining Manager Key(s).
b.
Press ` for 5 seconds until a two-tone beep is heard and the LED starts to flash.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns on.
d.
Touch the Programming Key to the key slot again until three sets of two-tone beeps are heard and the LED turns off.
All previously registered Manager Key(s) have been erased from the lock.
e.
Follow Register/Add Manager Key(s) instructions to register the remaining Manager Key(s).
Operating Instructions
Operate with any RFID Card or Access Credential:
▪
To lock: Close the door, press `, present any RFID Card or Credential to the Reader, then turn the knob/lever to
the locked position.
▪
To unlock: Press `, present the same RFID Card or Credential to the Reader, turn the knob/lever to the unlocked position,
then open the door.
Operate with any User Key:
▪
To lock: Close the door, touch any User Key to the key slot, then turn the knob/lever to the locked position.
▪
To unlock: Touch the same User Key to the key slot, turn the knob/lever to the unlocked position, then open the door.
Operate with a registered Manager Key*:
▪
To lock: Close the door, touch a registered Manager Key to the key slot, then turn the knob/lever to the locked position.
▪
To unlock: Touch a registered Manager Key to the key slot, turn the knob/lever to the unlocked position, then
open the door.
Operate with the Programming Key*:
▪
To lock: Close the door, press `, touch the Programming Key to the key slot, then turn the knob/lever to the locked position.
▪
To unlock: Press `, touch the Programming Key to the key slot, turn the knob/lever to the unlocked position, then
open the door.
*When locked with a registered Manager Key or the Programming Key, the previous RFID Card or User Key will continue to operate the lock.
Product Guide
RFID Cam Locks Advanced Security
Shared Use
DCR1-ATV1
www.digilock.com | [email protected]
Phone: 707 766 6000