- ページ 3
錠前 Digilock Lockup MのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Digilock Lockup M 4 ページ。 Keypad lock
ページを印刷するProgramming Instructions
LED Usage Indicator (for shared use functionality only)
When in shared use functionality, each lock can be programmed to have the LED fl ash or not fl ash while the lock is in use. The default
setting is ON (red LED fl ashes while lock is in use).
To turn off the LED Usage Indicator:
a.
Press =` 92 `. The LED will start to fl ash.
b.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
To turn on the LED Usage Indicator:
a.
Press =` 91 `. The LED will start to fl ash.
b.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
Assign User Credential (for assigned use functionality only)
Make sure that the lock is set for assigned use functionality. Once a user credential is assigned, the previously assigned user credential
will no longer operate the lock.
Assign a User Code (default user code = 1234):
a.
Press =` then touch a registered Manager Key to the key slot until the LED turns on.
b.
Press = [new 4-digit code] `. A two-tone beep will be heard.
c.
To confi rm, press = [the same 4-digit code] `. Two sets of two-tone beeps will be heard and the LED will turn off.
Assign a User Key:
a.
Press =` then touch a registered Manager Key to the key slot until the LED turns on.
b.
Touch a User Key to the key slot until a two-tone beep is heard and the LED turns off.
Operating Instructions
Operate with a User Code
For assigned use functionality:
▪
To unlock: Press = [assigned 4-digit code] `*.
▪
To relock: Press =``.
For shared use functionality:
▪
To lock: Press = [any 4-digit code] `.
▪
To unlock: Press = [the same 4-digit code] `*.
Operate with a User Key
For assigned use functionality:
▪
To unlock: Touch the assigned User Key to the key slot.
▪
To relock: Touch the assigned User Key to the key slot.
For shared use functionality:
▪
To lock: Touch any User Key to the key slot.
▪
To unlock: Touch the same User Key to the key slot.
Operate with a Registered Manager Key
▪
To unlock and lock: Touch a registered Manager Key.**
Operate with a Registered Programming Key
▪
To unlock and lock: Press =` then touch the Programming Key to the key slot.**
* The lock will go into Sleep Mode (keypad is disabled) after 3 consecutive incorrect user code entries.
** If a registered Manager Key or the Programming Key is used to unlock and then relock, the previous user credential will continue to operate the lock.
Product Guide
Keypad Locks
M
Shared & Assigned Use Functionality