- ページ 3
カードリーダー Digilock CurveのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Digilock Curve 11 ページ。 Keypad | basic & advanced
Digilock Curve にも: 製品マニュアル (8 ページ)
PROGRAMMING INSTRUCTIONS - ADDING KEYS
Add Manager Keys
Manager Keys can be programmed to the locks at any time.
1
Go to a lock requiring
additional Manager Keys.
Press
= ` 55 `
The LED will turn on.
PROGRAMMING INSTRUCTIONS - REPLACING KEYS
The locks must be reprogrammed to prevent lost/stolen keys from operating a lock.
To Replace the Programming Key
1
Note the order or serial number (found on the lock's rear unit).
To Replace the Manager Keys
1
Collect all remaining and any
new Manager Keys.
Go to any lock operated by the
lost/stolen Manager Keys.
3
P R O DU CT GU I D E
Keypad | Basic & Advanced
2
Insert the Programming Key.
A two-tone beep will be heard.
.
2
Press
= ` 55 `
The LED will turn on.
3
Insert each additional Manager
Key one at a time.
A two-beep will be heard
for each Manager Key
programmed.
2
Contact Digilock Support to purchase a replacement
Programming Key.
3
Insert the Programming Key.
.
A two-tone beep will be heard.
Reinsert the Programming Key
again. Three sets of two-tone
beeps will be heard and the
LED will turn off.
4
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each
lock or follow instructions to
Express Register Manager Keys
to quickly program multiple
locks to operate with the same
Manager Keys.
4
All previously programmed
Manager Keys will be erased.
Follow instructions to Add
Manager Keys to program the
remaining and replacement
Manager Keys to the locks.