- ページ 3

コンピュータ・アクセサリー crescendo 7200 G3のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。crescendo 7200 G3 9 ページ。 Processor upgrade card for power macintosh 7200/8200 computers

ページを印刷する

Hardware Installation-Power Mac 7200, 7215, WGS 7250

This section covers the configuration and installation of the Crescendo/7200 into

the Power Macintosh 7200, 7215 and Workgroup Server 7250. If you are

installing the Crescendo card into a Power Macintosh 8200, skip to page 6.

1. Shut down your computer. If the computer has been on for any length of

time, wait a few minutes for it to cool before beginning the installation.

2. With the front of the computer facing you, remove the case cover. Locate the

two switches on the underside of the front cover, depress them, and slide the

cover forward and off the computer (Figure 3).

3. Touch the power supply metal shielding (Figure 4) to discharge any poten-

tial damaging static electricity, then disconnect the power and peripheral

cables from the back of the computer.

Support Note:

To avoid generating a static charge in your body, do not

walk around the room until after you finish installing the Crescendo/7200

and close the computer.

4. Rotate the expansion card cover up and to the left (Figure 4).

5. Release the two latches that lock the internal assembly for the drive bay and

power supply in place (Figure 5).

6. Lower the assembly support stand (Figure 6).

7. Rotate the internal assembly out of the case (Figure 7).

internal assembly

Figure 3

expansion card cover

power supply

metal shielding

Figure 4

Figure 5

support stand

Figure 6

internal assembly

Figure 7