- ページ 7

スプレッダー Cresco 20WのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cresco 20W 18 ページ。 Fertilizer and salt spreader

Assembling your Cresco 20

Use the pliers to split the cotter pins on both

sides.

Thread the M6x35 bolt through the hole of the

handle bar (item 2) and lower frame (item 15).

Use the M6 wingnut to tighten. Repeat on both

sides.

Feed the other end of the control rod (item 16)

through the hole at the back of the control lever

(Item 18). Make sure you push the lever all the

way to the bottom.

ASSEMBLING THE HANDLE BAR AND CONTROL ROD:

Flip the spreader onto its wheels and ensure they

work correctly. Align the holes at the bottom of the

handle bar (item 2) with the holes at the top of the

lower frame (item 15). You may need to pull the ends

apart slightly to place in position.

Protruding from the back of the hopper body

(item 17) is a V-shaped metal (Item 21-pivot

bracket). Clip the L shaped end of the control

rod (item 16) into the hole on the V-shaped

metal.

Before tightening the control rod. Make sure the

application holes in the hopper are fully open

and the control lever is set at 20.

IMPORTANT