- ページ 8
防犯カメラ Digimerge DPD24WのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Digimerge DPD24W 18 ページ。 Ultra resolution tdn wdr varifocal dome
ページを印刷する
¡á Installation
¡áCable Connections
Ultra Resolution TDN WDR Varifocal Dome
DECORATION RING
DOME COVER
GIMBAL A'SSY
24V POWER BOARD
CONTROL BOARD
BASE HOUSING
POWER
VIDEO
DC only
RS-485(Optional)
AC24V
DC12V AC IN
AC IN
DC IN
DC IN
12
1. Dome Base Mounting
- Open the dome cover by loosening 3 screws using special wrench
provided.
- Mount the base of camera to a sturdy surface using 4 screws
(1.5 inch) and 4 premade holes on the base of the dome.
2. Power Connect & Monitor Impedance
- DC12V/300mA regulated power supply (DC12V only)
AC24V Class 2 power supply (AC24V/DC12V)
- To avoid fire or shock hazard, must use a UL listed power supply.
- Set the monitor impedance switch to 75¥Ø . Check the impedance
switch when the screen turns blurred.
3. Camera Module Adjustment
- Loosen screws for 3-axis camera bracket and adjust the direction
and angle of camera.
- Make sure to retighten the screws for camera bracket.
- Set any function you wish to activate by using the OSD buttons.
4. Dome Cover Mounting
- Replace the dome cover to the base and tighten 3 screws.
Control via RS-485 Interface (Optional)
The camera can be controlled by using an external controller equipped
with RS-485 communications.
• To control using a DVR or keyboard controller
Connect the RS-485 cable (TRX+, TRX-) to the connection port of the
485 control board in the DVR or controller.
485 Control Board Connection Port
(+) CONNECTION TERMINAL (TRX+)
(- ) CONNECTION TERMINAL (TRX-)
* RS-485 communication default initial values
Item
Camera ID
BAUD RATE
Initial value
1
2400
Note
• To control the camera use Pelco-D protocol.
- Set Preset 95 : Enters into OSD menu.
- Iris Open command : Set key function.
- Iris Close command : Cancel function.
13
RS-485 Control Port
485+
485-
UART MODE
PET PKT
8-NONE-1
ENABLE
Ultra Resolution TDN WDR Varifocal Dome