歩数計 Accusplit Eagle AE120XLのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Accusplit Eagle AE120XL 1 ページ。 Accusplit pedometer instuction manual
Accusplit Eagle AE120XL にも：取扱説明書 (1 ページ)

ページを印刷する

ACCUSPLIT®

EAGLE

AE120XL

Congratulations on taking the ﬁrst step to wellness with your

purchase of an ACCUSPLIT pedometer. Just put the pedometer

on as shown below, and start walking!

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer

onto your belt or the top edge of your pants or skirt. It should ﬁt

snugly and level, above one knee.

The pedometer should be as vertical as possible.

Note:

Walkers with larger stomachs may ﬁnd it helpful to wear the

pedometer farther back on the body, toward one hip.

The cover must be closed for the pedometer to work. To

avoid losing or dropping your pedometer, use the included

leash and clip to fasten the pedometer securely to your

clothing.

Attaching the Leash: Attach the pedometer to the leash by

looping the leash through the pedometer leash slot. Then,

clasp the waistband of your clothing with the metal alligator clip

attached to the other end of the leash. You can also use a safety

pin to fasten the leash to your clothing, loop the leash through

your belt or belt loop, or use a badge holder.

First, loop the

pedometer leash slot

Next, clasp clothing

with metal alligator clip

Or, loop a belt or belt loop

ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA

800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • [email protected]

™

Pedometer

INSTRUCTIONS

Or, loop a

badge holder,

then put into pocket

(Badge holder

not included)

DISPLAY MODES

• step: STEP mode shows your step count

since last reset, up to 100,000 steps.

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed, it will

automatically begin to record your steps.

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily. To reset: Press

and hold the yellow RESET button for at least 2 seconds.

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to

replace the battery. Your pedometer uses one Type LR44

1.5 volt silver oxide battery. To replace:

1. Insert a coin into the slot on the bottom of the case, and

twist counterclockwise to loosen the case front. Lift case

front away.

2. Using a pen or other thin object, push battery upwards

out of its holder. Replace it with a new battery. The

battery's positive (+) terminal should be FACE UP while

you put it into the pedometer.

3. Align case front over the pedometer and press gently to

snap cover back into place, starting with top.

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

See label inside unit cover for details, or check

http://support.ACCUSPLIT.com

Yellow: RESET

998-299B