- ページ 5

スイッチ Cisco 2960-CのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2960-C 25 ページ。
Cisco 2960-C にも：インストレーション・マニュアル (37 ページ)

Catalyst 3560-C and 2960-C Switch Getting Started Guide

Step 3

Approximately 30 seconds after the switch powers on, it begins the power-on self-test

(POST), which can take up to 5 minutes.

During POST, the SYSTEM LED blinks green, and the other LEDs turn green.

When POST is complete, the SYSTEM LED turns green, and the other LEDs turn off.

Troubleshooting:

If the SYSTEM LED blinks green, does not turn green, or turns amber, contact your Cisco

representative or reseller. The switch failed the POST.

Step 4

Press and hold the Mode button until all of the

LEDs next to the console port turn green. You

might need to hold the button for 3 to 5

seconds.

The switch is now in Express Setup mode.

Before going to the next step, make sure that

all LEDs next to the console port are green.

Troubleshooting:

If the LEDs blink after you press the Mode

button, release it. Blinking LEDs mean that

the switch is already configured and cannot

go into Express Setup mode. For more

information, see the

section on page

setup program described in the switch

hardware guide.

OL-23802-02

"Resetting the Switch"

21. You can also use the CLI

Catalyst 3560-C and 2960-C Switch Getting Started Guide

SY ST

ST AT

D PL X

SP D

M O D E

P oE

C O N S O