- ページ 2

スイッチ Cisco 2970 - Catalyst SwitchのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2970 - Catalyst Switch 19 ページ。 Ios software release 12.1(14)ea1
Cisco 2970 - Catalyst Switch にも：製品情報 (5 ページ), 製品サポート速報 (6 ページ), 製品サポート速報 (6 ページ)

ページを印刷する

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Catalyst 8510CSR, and 8540CSR Switches Console Port Pinouts

Related Information

Introduction

This document focuses on using the default parameters for connecting and configuring management

terminals. The switches covered in this document are the Catalyst 1900, 2820, 2900, 3500, 2940, 2950,

2970, 3550, 2948G-L3, 4000/4500, 4840G, 4908G-L3, 5000/5500, 6000/6500, and 8500 series switches.

For more information on using different connection speeds, cables, or devices, see the

Installation Guide

for your Catalyst series switch.

Before You Begin

Conventions

For more information on document conventions, see the

Prerequisites

There are no specific prerequisites for this document.

Identifying a Rollover Cable, Straight-through, and Crossover Cable

The information in this document is based on the software and hardware versions below.

The Catalyst series switches mentioned in this document require the use of either a rollover or

straight-through RJ-45 cable to connect a terminal to the console port depending on the type of

supervisor and other factors. Rollover cables and straight through cables have different pinouts than

crossover cables, which can be used to connect 10/100 base TX ethernet ports together between switches.

To identify the type of cable you are using, refer to

Ports.

The information presented in this document was created from devices in a specific lab environment. All

of the devices used in this document started with a cleared (default) configuration. If you are working in

a live network, ensure that you understand the potential impact of any command before using it.

Connecting a Terminal to Catalyst 1900/2820,

2900/3500XL, 2940, 2950, 2970, 3550, and 3750

Series Switches

Use the supplied rollover cable and the DB-9 adapter to connect a PC to the switch console port. You

http://www.cisco.com/warp/public/473/9.html (2 of 19) [9/4/2003 12:36:02 PM]

Cisco Technical Tips

RJ-45 Cables

Cabling Guide for Console and AUX

Hardware and

Conventions.