- ページ 19

スイッチ Cisco 3020 - Cisco Catalyst Blade SwitchのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3020 - Cisco Catalyst Blade Switch 31 ページ。 Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch にも：スタートマニュアル (37 ページ), クイックスペック (12 ページ), リリースノート (41 ページ), リリースノート (27 ページ), リリースノート (23 ページ), リリースノート (21 ページ), インストレーション・マニュアル (21 ページ)

Enter end.

Step 6

Enter copy running-configuration startup-configuration to save this setting.

Step 7

At the prompt, press Return.

Step 8

To verify that this switch is set as the stack master, enter the show switch user EXEC

Step 9

command.

For more information about creating switch stacks, see the "Planning and Creating a Switch Stack

(Only the Cisco Catalyst Blade Switch 3120 for HP)" section on page 23.

Managing the Switch Module

After you complete Express Setup and install the switch module in your network, use the device

manager or other management options described in this section for further configuration.

Using the Device Manager

The simplest way to manage the switch module is by using the device manager that is in the switch

module memory. This is a web interface that offers quick configuration and monitoring. You can

access the device manager from anywhere in your network through a web browser.

Follow these steps:

Launch a web browser on your PC or workstation.

Step 1

Enter the switch module IP address in the web browser, and press Enter. The device manager

Step 2

page appears (see Figure 10 and Figure 9).