- ページ 23

スイッチ Cisco 3750 - Catalyst EMI SwitchのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3750 - Catalyst EMI Switch 27 ページ。 Catalyst 3750 series switches
Cisco 3750 - Catalyst EMI Switch にも：データシート (18 ページ), インストールマニュアル (47 ページ), よくある質問 (10 ページ), 製品情報 (5 ページ), 製品サポート速報 (6 ページ), 製品概要 (25 ページ), 説明 (1 ページ), データシート (23 ページ), 製品サポート速報 (6 ページ), データシート (23 ページ), スタートマニュアル (33 ページ)

• Did you wait 30 seconds after you connected

the switch and the PC before you entered the

IP address in your browser?

• Did you enter the wrong address in the

browser, or is there an error message?

Resetting the Switch

This section describes how to reset the switch by rerunning Express Setup. These are reasons why you

might want to reset the switch:

• You installed the switch in your network and cannot connect to it because you assigned the

incorrect IP address.

• You want to clear all configuration from the switch and assign a new IP address.

• You are trying to enter Express Setup mode, and the switch LEDs start blinking when you press

the Mode button (which means that the switch is already configured with IP information).

Caution

Resetting the switch deletes the configuration and reboots the switch.

To reset the switch:

• Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue

holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch

reboots.

The switch now behaves like an unconfigured switch. You can enter the switch IP information by using

Express Setup as described in the "Running Express Setup" section on page 4.

First look for a solution to your problem in the troubleshooting section of the hardware installation

guide or the software configuration guide on Cisco.com. You can also access the Cisco Technical

Support and Documentation website for a list of known hardware problems and extensive

troubleshooting documentation.

If not, wait 30 seconds, re-enter 10.0.0.1 in the

browser, and press Enter.

If yes, re-enter 10.0.0.1 in the browser, and press

Enter.