- ページ 7

スイッチ Cisco 500 SeriesのPDF トラブルシューティングとメンテナンスをオンラインで閲覧またはダウンロードできます。Cisco 500 Series 15 ページ。 Stackable managed switches
Cisco 500 Series にも： 安全情報マニュアル (42 ページ), マニュアル (4 ページ), クイック・スタート・ガイド (13 ページ), クイック・スタート・マニュアル (21 ページ), データシート (5 ページ), ユーザーマニュアル (4 ページ), ユーザーマニュアル (6 ページ), ユーザーマニュアル (46 ページ), マニュアル (40 ページ), 管理マニュアル (48 ページ), マニュアル (24 ページ), クイック・リファレンス・マニュアル (7 ページ), クイック・スタート・マニュアル (25 ページ)

ページを印刷する
Cisco 500 Series トラブルシューティングとメンテナンス
Troubleshooting and Maintenance
Solution

Problems with Your Bluetooth Connection

The Cisco Headset 560 Series Multibase enables you to connect a call device through Bluetooth.
Bluetooth Does Not Turn On
Problem
Bluetooth doen't turn on when you press the Bluetooth button on the back of your multibase.
Solution
Contact your headset administrator to see if Bluetooth functionality has been disabled remotely.
Bluetooth LED Pulses White
Problem
The Bluetooth LED pulses white.
Solution
Related Topics
There is No Audio With Bluetooth Turned On
Problem
The Bluetooth LED shows solid white but you cannot hear any audio.
Check each headset's firmware to make sure that they have headset Firmware Release 1.5(1) or later.
Any headset that tries to start or join conferencing mode must have Firmware Release 1.5(1) or later.
Check with your administrator to make sure that conferencing mode is enabled.
Check that Bluetooth is activated on your desired call device.
If you have already paired your device, make sure that you select Cisco Headset XXX from the Bluetooth
menu and attempt to reconnect.
Note
The Multibase appears on your desired call device as Cisco Headset followed by
the last three digits of the base serial number. Your base serial number can be
found on the underside of your base.
Put the base in pairing mode and pair the call device to the base. To put your base in pairing mode, press
the Bluetooth button on the back of the base twice.
Connect the Multibase to a Bluetooth Device
Problems with Your Bluetooth Connection
Troubleshooting and Maintenance
7