- ページ 13
スイッチ Cisco 5509 - Catalyst Chassis SwitchのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 5509 - Catalyst Chassis Switch 17 ページ。 Wireless controller
Cisco 5509 - Catalyst Chassis Switch にも： インストレーション・マニュアル (34 ページ)
ページを印刷する
A
Inserting and Removing Modules
Caution
To prevent ESD damage to electronic components, always use an ESD wrist
strap when handling modules or coming into contact with internal components.
Inserting a module into the chassis
1
Align the edges of the module with the card guides on each side of the slot (see figure).
2
Ensure that the ejector levers are in the out position. Keeping the module horizontal, slide
the module into the slot until the ejector levers contact the chassis.
3
Push both ejector levers in simultaneously to seat the module in the backplane connector.
4
Tighten the captive screws with a flat-blade screwdriver.
3
4
Insert card
between card guides
FAST ETHERN ET SWITCH ING MODULE
Captive installation screw
Removing a module from the chassis
1
Loosen the captive screws on the module using a flat-blade screwdriver.
2
Pull the ejector levers outward simultaneously to release the module from the backplane
connector.
3
Pull the module straight out of the slot and place it on an antistatic mat or in an antistatic
bag.
SUPERVISOR ENGINE
SUPERVISOR ENGINE
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING MODULE
FAST ETHERNET SWITCHING
MODULE
FAST ETHERNET SWITCHING
MODULE
Ejector lever
13