- ページ 30

スイッチ Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module ExpansionのPDF インストレーション・ノートをオンラインで閲覧またはダウンロードできます。Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 ページ。 Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion にも：インストレーション・ノート (14 ページ), 解決マニュアル (17 ページ), インストレーション・ノート (46 ページ), ホワイトペーパー (19 ページ), 説明 (1 ページ), 製品情報 (6 ページ), お知らせ (4 ページ), データシート (9 ページ), データシート (18 ページ), ホワイトペーパー (18 ページ), 設定マニュアル (8 ページ), インストレーション・ノート (28 ページ), トラブルシューティングマニュアル (11 ページ), インストレーション・ノート (18 ページ), ユーザーマニュアル (17 ページ), インストレーション・ノート (24 ページ), マニュアル (19 ページ)

Removing and Installing Ethernet Modules in the Chassis

Fully open both ejector levers on the Ethernet module. (See

Step 3

Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the

Step 4

following two sets of substeps:

Horizontal slots

Position the Ethernet module in the slot. (See

module carrier with the slot guides on each side of the slot.

Carefully slide the Ethernet module into the slot until the EMI gasket along the top edge of the

module makes contact with the module in the slot above it and both ejector levers have engaged and

closed to approximately 45 degrees with respect to the Ethernet module faceplate. (See

Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create

a small (0.040 inch [1 mm]) gap between the module's EMI gasket and the module above it. (See

Figure

Do not press down too hard on the levers because they can bend and be damaged.

Caution

While gently pressing down, simultaneously close the left and right ejector levers to fully seat the

Ethernet module in the chassis backplane connector. The ejector levers are fully closed when they

are flush with the module faceplate. (See

Note

Tighten the two captive installation screws on the Ethernet module.

Note

Verify that the Ethernet module STATUS LED is lit. Check the STATUS LED periodically. If the

STATUS LED changes from orange to green, the module has successfully completed the boot

process and is now online. If the STATUS LED remains orange or turns red, the module has not

successfully completed the boot process and may have encountered an error.

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

20.)

Failure to fully seat the module in the chassis backplane connector can result in error

messages.

Make sure that the ejector levers are fully closed before tightening the captive installation

screws.

Figure

19.)

Figure

19.) Make sure that you align the edges of the

Figure

21.)

Figure

20.)

OL-24918-02