- ページ 11

スイッチ Cisco BTS 10200のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco BTS 10200 35 ページ。 Softswitch

Provision VLANs

Follow the procedures in this section to provision the VLANs on the Cisco 2924M Ethernet Switches

(Hubs). You will need to enter a password to log on to these hubs.

Follow these steps to provision the VLANs on the Cisco 2924M Ethernet Switch A (Hub A):

Step 1

Connect a console cable to the Hub A console port. Use

machine is designated as Hub A.

Switch> Enter: enable

Step 2

Step 3

The system will prompt you for a password. Enter the password.

Step 4

Switch# Enter: config t

Note

Step 5

Copy the entire config text and paste at the Switch (config)# prompt.

Tip

If you are viewing a pdf file, you can get an electronic copy of this config text using the following

method: Select the "Text Select Tool" (the large "T" in the Adobe Acrobat toolbar above this file). Select

all the config text on this page (Acrobat allows you to copy from only one page at a time.) Use the

Edit/Copy feature (or right click) to get an electronic copy. Paste into a text document. Repeat on the

following pages until you have all the necessary text in your text file. Copy all the text in your text file,

and paste it into your XTerm window.

The config text (for

OL-2906-01

C I S C O C O N F I D E N T I A L

The system will respond with the following prompt: Switch (config)#

Step

5) is as follows. See the Tips paragraph above for assistance with copying:

hostname switch-a

interface FastEthernet0/1

description 120-Network Name-Redundancy1

switchport access vlan 146

interface FastEthernet0/2

description 120-Network Name-Redundancy1

switchport access vlan 146

interface FastEthernet0/3

description 120-Network Name-Redundancy1

switchport access vlan 146

Figure 1 on page 2

to help identify which

Provision VLANs