- ページ 9
スイッチ Cisco C-series Nexus 5010のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco C-series Nexus 5010 11 ページ。 Replacing an i/o module nexus 5000 series
Cisco C-series Nexus 5010 にも： 仕様 (3 ページ), データシート (23 ページ), リリースノート (26 ページ), リリースノート (3 ページ), ハードウェア・インストール・マニュアル (19 ページ)
ページを印刷する
Chapter 1
Product Overview
Typical Deployment Topologies
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
IOC Topology
Figure 1-3
shows a typical I/O consolidation (IOC) scenario for the Cisco Nexus 5000 Series switch.
Figure 1-3
I/O Consolidation Topology
SAN-A
LAN Core
SAN-B
Distribution
layer
Cisco
Access Layer
Nexus
Switch
The Cisco Nexus 5000 Series switch connects to the server ports using FCoE. Ports on the server require
converged network adapters. For redundancy, each server connects to both switches. Dual-port CNA
adapters can be used for this purpose. The CNA is configured in active-passive mode, and the server
needs to support server-based failover.
On the Cisco Nexus 5000 Series switch, the Ethernet network-facing ports are connected to two Catalyst
6500 switches. Depending on required uplink traffic volume, there may be multiple ports connected to
each Catalyst 6500 switch, configured as port channels. If STP is enabled in the data center LAN, the
links to one of the switches will be STP active and the links to the other switch will be STP blocked.
The SAN network-facing ports on the Cisco Nexus 5000 Series switch are connected to Cisco MDS 9000
Family switches. Depending on required traffic volume, there may be multiple Fibre Channel ports
connected to each MDS 9000 Family switch, configured as SAN port channels.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-9
OL-16597-01