- ページ 12

ミュージックペダル BYOC Vibrato BA662AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BYOC Vibrato BA662A 15 ページ。

Assembly

1. Install the SPDT toggle switch

VERY IMPORTANT!!!!

Take off the extra bold and

washer from the inside of the brushing so that there is only one bolt and one washer (the

serated washer) on the outside of the enclosure on the body of the switch is flush against the

inside of the enclosure. When the swithc is in the up positions, this will be ramp on .

2. Install the pots so that the depth pot is in the midde, the rate pot is on the right and the rise

time pot is on the left .

3. Install the footswitches so that the ramp switch is on the left and the bypass switch is on

the right. Orientate the bypass switch so that the solder lugs are facing horizontally. The

ramp switch is a SPST switch, so it doesn't matter which it the pole and which is the throw.

4. Install the AD adaptor jack. Orientate it so that the negative tip terminal is on the left,

the battery connect + terminal is in the middle and the constant + terminal is on the right.